Removing Right-Side Components - Arctic Cat 2015 400 Service Manual

AT THIS POINT

To service any one specific component, only limited dis-
assembly of components may be necessary. Note the
AT THIS POINT information in each sub-section.
 NOTE: The engine/transmission does not have to
be removed from the frame for this procedure.
Removing Right-Side
Components
A. V-Belt Cover
B. Driven Pulley
C. Clutch Cover
1. If the engine is still in the frame, remove the cap
screw securing the brake pedal to the pivot shaft.
Account for a flat washer.
2. Remove the cap screws securing the V-belt cover to
the clutch cover; then slide the brake pedal outward
and remove the V-belt cover. Account for two align-
ment pins and a gasket.
3. Mark the movable drive face and the fixed drive face
for installing purposes; then remove the nut holding
the movable drive face onto the crankshaft.
4. Remove the movable drive face and spacer. Account
for the movable drive face rollers and outer drive
face cover.
KC149A
KC142A
5. Remove the V-belt.
MD1033
MD1035
MD1034
MD1036
53