Lcd Gauge - Arctic Cat 2015 400 Service Manual

INSTALLING
1. Install the steering post into the frame and secure the
lower end in the bearing with a flat washer and cap
screw. Tighten to 40 ft-lb.
2. Apply grease to the inner and outer housings of the
upper steering post support; then with the housing
cap in place, secure with the cap screws. Tighten to
20 ft-lb.
3. Using red Loctite #271 on the threads, install the tie
rod ends into the lower steering post arm and tighten
to 30 ft-lb; then install new cotter pins.
4. Place the handlebar and caps in place on the steering
post and with the handlebar correctly positioned,
tighten the cap screws to 20 ft-lb.
5. Install the steering post cover; then install the front
body panel/fender.
KC184B
REPLACING
1. Remove the two screws securing the instrument pod
to the frame.
KC307A
2. Unplug the gauge from the wiring harness; then
remove the nuts and bracket securing the gauge to
the instrument pod.
KC184A

LCD Gauge

KC0058
KC507A
KC516A
21