Arctic Cat 2015 400 Service Manual page 83

8. Using a suitable block, support the rear of the tank;
then remove the clamp securing the gasline hose and
remove the hose from the fuel shut-off valve.
! WARNING
Gasoline may be under pressure. Place an absorbent
towel under the connector to absorb any gasoline spray
when disconnecting.
9. Remove the gas tank to the rear and account for heat
shield.
CLEANING AND INSPECTING
1. Clean all gas tank components with parts-cleaning
solvent.
2. Inspect all hoses for cracks or leaks.
3. Inspect tank cap and tank for leaks, holes, and dam-
aged threads.
INSTALLING
1. Using straps to hold the front plastic open, place the
gas tank into position in the frame making sure the
heat shield is in position.
KC514A
2. Using a suitable block, support the rear of the tank
and connect the gasline hose. Secure with the
clamp.
3. Remove the block and slide the tank forward, con-
nect the fuel level sensor wires, and insert the cap
screw into the rear of tank. Tighten securely.
KC241A
4. Remove the straps; then using the existing cap
screws, install the instrument pod. Tighten securely.
5. Secure the rear of the front body panel to the frame
with the cap screws (A) and tighten securely; then
install the gas tank cover and secure with the rein-
stallable rivets (B).
KC252A
KC241A
KC514
81