Arctic Cat 2015 400 Service Manual page 99

 NOTE: In some instances it may be necessary to
use an appropriate axle puller to remove the axle
from the differential.
11. Remove the cap screws from the drive coupler
flange; then remove the upper and lower mounting
cap screws and remove the differential from the
frame.
Disassembling Input Shaft
 NOTE: This procedure can be performed on a rear
gear case; however, some components may vary
from model to model. The technician should use dis-
cretion and sound judgment.
1. Remove the cap screws securing the front drive actu-
ator and remove the actuator.
KC425A
2. Remove the cap screws securing the pinion housing;
then using a rubber mallet, remove the housing.
Account for a gasket. Note the location of all the
components for assembling purposes.
3. Using a side-cutter, remove the boot clamps; then
remove the boots and splined drive from the input
shaft.
4. Remove the input shaft from the pinion housing.
KC486
5. Using the Multi-Seal Remover, remove the input
shaft seal. Account for a spacer.
KC488A
6. Remove the snap ring securing the input shaft bear-
ing; then place the pinion housing in a press and
remove the bearing.
CD102
CD107
AF982
97