Ice Maker Inlet Heated Fill Tube; Meat Pan Air Baffle Motor And Thermistor - KitchenAid 2003 M Technical Education

Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
ICE MAKER INLET
HEATED FILL TUBE
Refer to page 4-8 for the procedure for servic-
ing the ice maker inlet heated fill tube.
NOTE: The heated fill tube will be energized for
90 minutes after each ice maker harvest and
fill.
1. Unplug refrigerator or disconnect power.
2. Disconnect the ice maker inlet heated fill
tube wire connector from the main har-
ness.
3. Set the ohmmeter to the R x 1K scale.
4. Insert the ohmmeter test leads into the two
connector pins of the ice maker inlet heated
fill tube connector. The meter should indi-
cate approximately 7200 Ω.
Electrical Shock Hazard
MEAT PAN AIR BAFFLE MOTOR
AND THERMISTOR
Meat Pan Air Baffle Assembly
Harness Connector Here
Refer to page 4-20 for the procedure for servic-
ing the meat pan air baffle and thermistor.
1. Unplug refrigerator or disconnect power.
2. Disconnect the meat pan air baffle motor
and the thermistor wire connectors from
the main harness.
3. Set the ohmmeter to the R x 1K scale.
4. Touch the ohmmeter test leads to connec-
tor pins 5 and 6 of the meat pan air baffle
motor. The meter should indicate approxi-
mately 8450 Ω ±6%.
5. Touch the ohmmeter test leads to the two
connector pins of the meat pan air baffle
motor thermistor. The meter should indi-
cate as shown in the chart.
TEMPERATURE
(° F)
OHMS (APPROX.)
–5
0
5
10
15
20
25
30
32
35
4 0
5-10
Thermistor Connector
Pin 4
RESISTANCE TEMPERATURE
(° F)
25900-27500 4 5
22100-23500 50
18900-20000 55
16200-17200 60
13900-14800 65
12000-12800 70
10400-11000 75
8990-9550 80
8750 85
7800-8290 90
6800-7220
4 Connector
Harness
Assembly
RESISTANCE
OHMS (APPROX.)
5930-6300
5190-5510
4550-4830
4000-4240
3520-3730
3100-3300
2740-2910
2430-2580
2160-2290
1920-2030