KitchenAid 2003 M Technical Education page 92

5. IMPORTANT: The auger assembly is now
loose and the ice crusher blades and
spacers will slide off the auger shaft if you
do not hold them in place. Reach inside
the bin and lift the mounting plate just
enough so you can grasp the end of the
auger shaft, then lift the auger assembly
out of the bin, and lay it on the work sur-
face.
6. Remove the auger components from the
auger shaft and lay them, in order, on your
work surface for easy reassembly.
REASSEMBLY NOTE: Make sure that you
position the mounting plate and the blade as-
sembly (oval inset) on the auger shaft properly
(see the photo above).
Shoulder
Spacer
Shoulder
Spacer
6 Spacers
Blade C
Blade A
Blade B
Nylon
Mounting Plate
Flat Washer
Auger Assembly
Blade Assembly
Spreader
Auger
LATCH ASSEMBLY REMOVAL
1. Use a small screwdriver, and insert the
blade under the locking tab of the latching
arm.
2. Pull on the latching arm while prying up on
the locking tab, and align the slots in the
arm with the tabs of the bin, then lift the
arm, and remove it. NOTE: The latching
arm spring and pushbutton will come loose
when the arm is removed.
Tab
Slot
Latching Arm
Spring
Pushbutton
8-2
Pull On Latching Arm
Locking Tab
Tab & Slot Aligned