KitchenAid 2003 M Technical Education page 27

d) Disconnect the wire connectors from
the door switch terminals.
2 Wire
Connectors
e) Press against the locking tab on the
switch body and push the switch out of
the bracket.
Push Switch Out Of Bracket
6. To remove the power switch:
a) Remove the two hex-head screws from
the switch bracket and turn the bracket
over so you can access the wires.
Power Switch
REASSEMBLY NOTE: When you reinstall the
power switch in the bracket, be sure to position
the switch with the On and Off markings as
shown below. The switch wiring is also shown
below. The terminal numbers are shown on the
switch body.
Bracket Screws
4-3
b) Disconnect the wire connectors from
the switch terminals. NOTE: Be sure
to reconnect the wires to the same ter-
minal locations, as shown below.
c) Press against the four locking tabs on
the body of the power switch, and push
the switch out of the bracket.
Switch Locking Tabs
6
Power Cord (Smooth)
5
Black Wire
4
N/C
4 Wire Connectors
(2 of 4)
3
Power Cord (Ribbed)
2
White Wire
1
N/C