KitchenAid 2003 M Technical Education page 49

d) Disconnect the two ice maker connec-
tors from the freezer wiring harness
and remove the ice maker from the
freezer.
e) Remove the three hex-head screws
from the bottom of the ice maker bracket
and remove the bracket from the ice
maker
Bottom 3 Bracket Screws
5. To remove the emitter module:
a) Remove the three screws from the emit-
ter module and pull it out of the freezer
liner opening.
Screw (1 of 3)
2 Wire
Connectors
Emitter
Module
b) Disconnect the harness connector from
the emitter module board and remove
the module.
Emitter
Connector
6. To remove the receiver module:
a) Remove the three screws from the re-
ceiver module and pull it out of the
freezer liner opening.
Receiver
Module
Screw (1 of 3)
b) Disconnect the harness connector from
the receiver module board and remove
the module.
4-25
Receiver
Connector