Scanning Bar Codes - Intermec CK31 User Manual

Chapter 1 — Using the CK31 Handheld Computer
Changing the Beeper Volume
Method
Use the keypad.
Use the Intermec
Settings application.
Use the Beeper
Volume command.

Scanning Bar Codes

Do not look directly into the window area or at a reflection
of the laser beam while the laser is scanning. Long-term
exposure to the laser beam can damage your vision.
Use the scanner to scan and enter bar code data. The type of
scanner you are using and the type of bar code you are decoding
determines the way you scan the bar code. The CK31 supports
the scanning of 1D linear bar codes and 2D images, depending
on the scanner model in your CK31. Plus, the way you scan bar
codes is different if you are using an integrated handle or a
scanner attached to the serial port.
When you unpack the CK31, these bar code symbologies are
enabled:
• Code 39
• Code 128
• PDF417 (if supported)
• UPC/EAN
• DataMatrix (area imagers only)
If you are using bar code labels that are encoded in a different
symbology, you need to enable the symbology on the CK31.
Use Intermec Settings to enable and disable symbologies for
your scanner. For help, see "Configuring the CK31 With
Intermec Settings" on page 38.
22
Procedure
Press C and then press E to increase the
volume. There are five beep volumes on the
CK31 including off. When you reach the
loudest setting, the next setting is off.
Go to Start > Intermec Settings > Device
Settings > Beeper > Volume.
For help, see "Beeper Volume" in the Intermec
Computer Command Reference Manual.
CK31 Handheld Computer User's Manual