Intermec CK31 Instructions

Tethered stylus

Hide thumbs Also See for CK31:

See also: Operator's Manual , User Manual

Enlarged version

CK31 Tethered Stylus Instructions

Attach a CK31 tethered stylus to your CK31 Handheld Computer

to make sure you can always find your stylus. The tethered stylus

installs easily on the back of the CK31 with a single screw.

Unpacking the Tethered Stylus

The tethered stylus comes in a plastic bag with this instruction

sheet and these items:

Tethered

stylus

Follow these instructions to install the tethered stylus on the CK31.

You will need a small Phillips screwdriver.

To install the tethered stylus

1 Secure the retaining bar to the back of the CK31 with the screw.

Screw

Retaining

bar

Retaining

bar

Table of Contents

Do you have a question about the CK31 and is the answer not in the manual?

Page 1 Installing the Tethered Stylus Follow these instructions to install the tethered stylus on the CK31. You will need a small Phillips screwdriver. To install the tethered stylus 1 Secure the retaining bar to the back of the CK31 with the screw. Retaining...
Page 2 2 Thread the loop on the end of the stylus assembly under the retaining bar. 3 Insert the stylus through the loop and tighten the small loop. 4 Insert the stylus into the holder on the CK31. Insert stylus into holder...