Fin Cover - Toshiba TECRA R10 Maintenance Manual

4 Replacement Procedures
4.8 FIN COVER ASSY
NOTE: When repairing the computer, clean the cooling fin with a vacuum cleaner.
Do not use cotton sticks and tweezers to remove dusts. It may cause the cooling
module problem or dusts stuffed.
Removing the FIN COVER ASSY
To remove the FIN COVER ASSY, follow the steps below and refer to Figure 4-8.
1. Loosen the screw securing the FIN COVER ASSY.
2. Insert your finger into the slit and remove the FIN COVER ASSY up.
FIN COVER ASSY
Installing the FIN COVER ASSY
To install the FIN COVER ASSY, follow the steps below and refer to Figure 4-8.
1. Set the FIN COVER ASSY into the slot.
2. Secure the FIN COVER ASSY with the screw.
4-20 [CONFIDENTIAL]
Figure 4-8 Removing the FIN COVER ASSY
4.8 FIN COVER ASSY
Screw
Slit
TECRA R10 Maintenance Manual (960-708)