4.22 DC FAN
8. Secure the H SINK PLT and VGA PLATE HOLDER (only for external graphics
chip model) with the following screws.
• M1.6×4C
• M1.6×4C
NOTE: When securing the H SINK PLT and VGA PLATE HOLDER, be sure to secure
the screws in the order of the number marked on the plate.
9. Set the DC FAN assembly in place and connect the DC FAN harness to the
connector CN8771 on the system board.
10. Fix the RGB harness to the DC FAN with INSU RGB HNS.
TECRA R10 Maintenance Manual (960-708)
×4
OTHER screw
×2 (for external Graphics chip)
OTHER screw
4 Replacement Procedure
[CONFIDENTIAL]
4- 57