3.20 ONLY ONE TEST
Subtest 7
Acceleration sensor
This subtest detects and corrects the each axis (X, Y, Z).
NOTE: Make sure that this subtest is executed on the following condition:
1. Flat desk with vertical plane to get the stability of machine.
2. The vertical wall or plane is necessary.
3. Prevent the machine from shake or shock.
<Example>
Set the machine
against the vertical plane
with the Front upward
Flat desk
The figure below shows the name and position of each side.
Left side
TECRA R10 Maintenance Manual (960-708)
Top
(heaven surface)
Back
[CONFIDENTIAL]
3 Tests and Diagnostics
Vertical plane
Right side
Front
3-47