4.26 LCD COVER ASSY
4.26 LCD COVER ASSY
Removing the LCD COVER ASSY
To remove the LCD COVER ASSY, follow the steps below and refer to Figure 4-38.
1. Open the LCD COVER ASSY at angle of 90 degree to the COVER ASSY.
2. Set the COVER ASSY on a flat desk as shown below.
3. Remove the following screws fixing the BH L ASSY and BH R ASSY (right and left
hinges). (The GND SPG FIN is secured together with the BH L ASSY)
• M2.5×6C
4. Remove LCD COVER ASSY with the BH L ASSY and BH R ASSY from the
COVER ASSY.
COVER ASSY
GND SPG FIN
TECRA R10 Maintenance Manual (960-708)
TAPPING Screw
BH L ASSY
LCD COVER ASSY
Figure 4-38 Removing the LCD COVER ASSY
4 Replacement Procedure
× 2 (1 each)
M2.5x6C TAPPING
[CONFIDENTIAL]
BH R ASSY
4- 65