Display Troubleshooting - Toshiba TECRA R10 Maintenance Manual

2 Troubleshooting Procedures

2.10 Display Troubleshooting

This section describes how to determine if the computer's display is functioning properly.
Start with Procedure 1 and continue with the other procedures as instructed.
Procedure 1: Diagnostic Test Program Execution Check
Procedure 2: Connector Check and Cable Check
Procedure 3: Replacement Check
Procedure 1 Diagnostic Test Program Execution Check
The Display Test program is stored on the computer's Diagnostics disk. This program checks
the display controller on the system board. Insert the Diagnostics disk in the computer's
floppy disk drive, turn on the computer and run the test. Refer to Chapter 3, Tests and
Diagnostics for details. If an error is detected, go to Procedure 2.
Procedure 2 Connector Check and Cable Check
Check 1 Make sure the LCD cable is securely connected to CN5000 on the system board.
If the connection is loose, reconnect firmly and restart the computer. If there is still an error,
go to Procedure 3.
2-42 [CONFIDENTIAL]
2.10 Display Troubleshooting
TECRA R10 Maintenance Manual (960-708)