Toshiba TECRA R10 Maintenance Manual page 303

4.29 LCD unit
Installing the LCD unit
To install the LCD unit, follow the steps below and refer to Figure 4-46 to 4-50.
1. Connect the LCD harness to the connector of the LCD unit.
2. Stick a new INSU HNS CONN on the LCD connector and LCD HARNESS
(connector).
CAUTION: Stick a new LCD HNS CONN as shown below.
3. Install the LCD unit to the LCD COVER ASSY in place.
CAUTION: Arrange the LCD harness, CAMERA HARNESS and antenna cables as
shown below.
LCD harness
TECRA R10 Maintenance Manual (960-708)
Arrange the cables between the
ribs on LCD COVER.
4 Replacement Procedure
LCD connector
CAMERA HARNESS,
antenna cables
[CONFIDENTIAL] 4- 77