Toshiba TECRA R10 Maintenance Manual page 75

2.4 System Board Troubleshooting
Debug BIOS processing
Code
F131 end of a display setting
F132 Password processing
F133 setup of ICH (DMAC)
setup of ICH (PCI)
CPU setup
setup of ICH (MEM IO)
F134
Display setup
setup of PIT
setup of ICH (PIC)
F135 setup of ICH
F136 end of Resume processing
F137 Setup of RAM
F138 Setup of RAM
NOTE: Status outputted by the test means the last error detected in the debug port test.
Check 1 If the D port is status F11Eh or F120h is displayed, go to "HDD Trouble shooting
Procedure in Section 2.6.
Check 2 If any other D port status error code is displayed, perform Procedure 3.
D port error code is as follows:
Error code
F003h or F004h
F00Bh
F117h
F121h
TECRA R10 Maintenance Manual (960-708)
Table 2-6 Debug port error status (3/8)
Target Device
EC/KBC(EC)
ICH(USB controller)
ICH(DMAC)
ICH(CMOS,MEM I/O, PIT
Controller, PIC Controller)、
EC/KBC(EC,KBC)、
BIOSROM、
Contents
SC initialization error
BIOS update error
Exception check error
Clock generator error
2 Troubleshooting Procedures
IC No.
IC3200(EC/KBC)
VGA IC1600 (ICH)
CN1400,CN1410(RAM
RAM Conn)
IC1600 (ICH)
IC1600 (ICH)
IC3200(EC/KBC)
CN1400,CN1410(RAM
Conn)
RAM、
IC3000(BIOS ROM)
IC1050(CPU)
CPU
ICH IC1600 (ICH)
-
CN1400,CN1410(RAM
RAM
Conn)
CN1400,CN1410(RAM
RAM
Conn)
[CONFIDENTIAL] 2-25