Toshiba TECRA R10 Maintenance Manual page 217

3.32 SETUP
(d) SATA Controller Mode
This feature sets the SATA Controller Mode.
AHCI
Compatibility
10. PCI Bus
This option displays the interrupt level for the Card Bus in the computer. It is for
information only and cannot be changed.
PCI BUS
11. Display
This group of options configures the computer's display.
(a) Power On Display
This option is used to select the display when booting up.
Auto-Selected
LCD+AnalogRGB
NOTE: Pressing Fn+F5 changes the display setting in the order of internal LCD to
simultaneous to external monitor.
12. Peripheral
Use this option to select the peripheral's mode.
(a) Internal Pointing Device
This option enables or disables the touch pad
Enabled
Disabled
TECRA R10 Maintenance Manual (960-708)
Sets AHCI which is the mode for VistaTM (default)
Sets the mode for legacy OS. Use this mode when the
driver corresponding to AHCI is not used.
= IRQ10, IRQ11
Selects an external monitor if one is connected.
Otherwise it selects the internal LCD. (Default)
Selects both the internal LCD and the external monitor
for simultaneous display.
Enables the touch pad. (Default)
Disables the touch pad.
[CONFIDENTIAL]
3 Tests and Diagnostics
3-95