Cover Assembly And Base Assembly - Toshiba TECRA M9 Maintenance Manual

4 Replacement Procedures

4.14 Cover assembly and Base assembly

Removing the cover assembly and base assembly
The following describes the procedure for removing the cover assembly and base assembly.
(See Figure 4-24 and 4-25.)
1. Close the display and turn over the computer.
2. Remove the following screws.
• M2.5×8B
• M2.5×16B
8
8
16
Figure 4-24 Removing the cover assembly and base assembly (1)
4-36 [CONFIDENTIAL]
FLAT HEAD screw
FLAT HEAD screw
16
16
4.14 Cover assembly and Base assembly
×3 ("8" in the figure below)
×6 ("16" in the figure below)
8
16
16
TECRA M9 Maintenance Manual (960-631)
16