Toshiba TECRA R10 Maintenance Manual page 248

4 Replacement Procedures
3. Remove the following screws and ODD REAR BRKT.
•
M2.0×2.7C
4. Remove the following screw and ODD SIDE BRKT.
•
M2.0×3C
ODD REAR BRKT
M2.0x2.7C STEP
Installing the Optical disk drive
To install the Optical disk drive, follow the steps below and refer to Figure 4-9 to 4-10.
1. Set the ODD REAR BRKT to the optical disk drive and secure them with the following
screws.
•
M2.0×2.7C
2. Set the ODD SIDE BRKT to the optical disk drive and secure them with the following
screw.
•
M2.0×3C
3. Insert the ODD ASSY into the slot to connect it to the connector on the system board and
secure optical disk drive assembly with the following screws.
•
M2.5×6C
CAUTION: Drive the screws in the order shown in the Figure 4-9.
4-22 [CONFIDENTIAL]
STEP screw
S-THIN HEAD screw
Figure 4-10 Removing the Optical disk drive (2)
STEP screw
S-THIN HEAD screw
FLAT HEAD screw
4.9 Optical disk drive (DVD-Super Multi drive)
×2
×1
Optical disk drive
ODD SIDE BRKT
M2.0x3C S-THIN HEAD
×2
×1
×2
TECRA R10 Maintenance Manual (960-708)