[Center Staple Position] - Muratec MFX-C2280 User's Manual Copy Operations

[Center Staple Position]

To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Finisher Adjustment]
- [Center Staple Position]
If the staple position is not on the fold line on saddle-stitched paper, use this option to align the staple posi-
tion on the fold.
Copy after configuration, then repeat adjustments as required.
Settings
[Paper Size]
[Adjust Value]
Tips
- This item is available when the Finisher C2280FN2 and Saddle Stitcher C2280SD are are installed.
- Adjust the half-fold position before adjusting the center staple position.
- Make adjustment while checking paper stapled at a displaced position.
- The value you set by selecting [All] in [Paper Size] will be added to the setting for each paper size.
- For adjustments to put staples parallel with the left edge of paper, contact your service representative
for instructions.
Description of Setup Buttons (Administrator Settings)
Description
Select the size of paper that is used to adjust the staple position.
Enter an adjustment value between -10.0 mm and 10.0 mm by tapping [-]
and [+].
• [-]: Move the staple position to the left.
• [+]: Move the staple position to the right.
[0.0 mm] is specified by default.
17
17-18