[1St Tri-Fold Position Adjustment] - Muratec MFX-C2280 User's Manual Copy Operations

[1st Tri-Fold Position Adjustment]

To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Finisher Adjustment]
- [1st Tri-Fold Position Adjustment]
If the tri-fold positions are not located evenly, use this option to adjust the first fold position.
Copy after configuration, then repeat adjustments as required.
Settings
[Paper Size]
[Adjust Value]
Tips
- This item is available when the Finisher C2280FN2 and Saddle Stitcher C2280SD are installed.
- Make adjustment while checking paper folded at a displaced position.
- The value you set by selecting [All] in [Paper Size] will be added to the setting for each paper size.
Description of Setup Buttons (Administrator Settings)
Description
Select the size of paper that is used to adjust the fold position.
Enter an adjustment value between -10.0 mm and 10.0 mm by tapping [-]
and [+].
• [-]: Move the fold position to the left.
• [+]: Move the fold position to the right.
[0.0 mm] is specified by default.
17
17-20