[Media Adjustment]; [Center Staple Position] - Muratec MFX-C2828 User's Manual Copy Operations

7.1 [System Settings]

[Media Adjustment]

Adjust defective print images caused by paper type features.
1
Press the Utility/Counter key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment]
ö [Printer Adjustment] ö [Media Adjustment].
2
Select a paper type to be adjusted.
% If defective images exist on the back side of 2-sided copy paper, select [2nd Side].
3
Press [+] or [-] to specify an adjusted value.
% If missing parts or white spots exist in print images, press [-]. If the surface of the print image is
rough, press [+].
4
Press [OK] ö [Close].
5
Copy, and then check the print image.

[Center Staple Position]

Adjust the stapling position for each paper size when printing with the center staple function.
0 Adjust the half-fold position before adjusting the center stapling position.
0 Before making any adjustments, create a sample using the center staple function. Adjust the center sta-
ple position while checking the created sample.
0 This adjustment is available if the Saddle Stitcher SD-509 is installed.
0 When stapling in parallel with the left edge of paper, contact your service representative.
1
Press the Utility/Counter key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment]
ö [Finisher Adjustment] ö [Center Staple Position].
2
Select the size of paper of which the center staple position is adjusted.
3
Press [+] or [-] to adjust the staple position while checking the sample.
4
Press [OK].
5
Create a sample, and check the print result.
d
Reference
To adjust the half-fold position:
Press the Utility/Counter key ö [Administrator Settings] ö [System Settings] ö [Expert Adjustment] ö [Fin-
isher Adjustment] ö [Half-Fold Position].
7
7-13