[Job Reset]; [Standard Size Setting]; [Stamp Settings] ([System Settings]) - Muratec MFX-C2280 User's Manual Copy Operations

[Job Reset]

To display: [Utility] - [Administrator Settings] - [System Settings] - [Reset Settings] - [Job Reset]
Select whether to reset settings for the conditions that are applied when changing users or loading document
to the ADF.
Settings
[When Account is changed]
[When original is set on
ADF]
[Next Job]
[Default Basic/Enlarge Dis-
play Common Setting]

[Standard Size Setting]

To display: [Utility] - [Administrator Settings] - [System Settings] - [Standard Size Setting]
Specify the detection capability setting of the size of the original in the Original Glass and the Foolscap paper
size setting.
For details, contact your service representative.

[Stamp Settings] ([System Settings])

To display: [Utility] - [Administrator Settings] - [System Settings] - [Stamp Settings]
Register header/footer programs and specify the stamp setting when sending a fax.
Settings
[Header/Footer Settings]
[Fax TX Settings]
Description of Setup Buttons (Administrator Settings)
Description
Specify whether to initialize all settings (except registered settings) when
the key counter or management card is removed.
[Reset] is specified by default.
Specify whether to reset all settings (except registered settings) when doc-
ument is loaded on the ADF.
[Do Not Reset] is specified by default.
Select whether to reset Staple Setting, Original Set/Bind Direction settings,
and TX Settings for each job.
• [Staple Setting]: Select whether or not to take over the settings upon
completion of a job for which Staple has been specified.
[OFF] is specified by default.
• [Original Set/Bind Direction]: Select whether or not to take over the set-
tings upon completion of a job for which Original Set and Bind Direction
have been specified.
[OFF] is specified by default.
• [Reset Data After Job]: Select whether to reset all settings or destina-
tions only when resetting settings for each job in Scan/Fax TX Settings.
If you select [Confirm with User], a confirmation screen appears that
asks you if you are sure to reset settings or destinations.
The default is [Reset All].
Select whether to configure the initial values for Normal and Enlarge Dis-
play mode at the same time.
If [Apply to all] is selected, [Default Enlarge Display Settings] does not ap-
pear. Initial values for each mode that are changed in [Default Copy Set-
tings] or [Default Scan/Fax Settings] are applied to both Normal and
Enlarge Display modes.
[Do not Apply] is specified by default.
Description
You can register header/footer programs, and change or delete registered
programs.
For details, refer to page 17-32.
Select whether to cancel stamp setting when sending a fax.
For details, refer to "User's Guide [Fax Operations]/[Description of Setup
Buttons (Administrator Settings)]".
17
17-31