[Punch Horizontal Position Adjustment] - Muratec MFX-C2280 User's Manual Copy Operations

[Punch Horizontal Position Adjustment]

To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Finisher Adjustment]
- [Punch Horizontal Position Adjustment]
If the positions of the punch holes on the paper are displaced sideways, use this option to adjust the punch
hole positions.
Copy after configuration, then repeat adjustments as required.
This adjustment is possible when the Finisher C2280FN2 and Saddle Stitcher C2280SD are installed.
Settings
[Paper Type]
[Adjust Value]
Tips
- Make adjustment while checking a sheet of paper having punched holes that are not in the correct po-
sitions.
Description of Setup Buttons (Administrator Settings)
Description
Select the type of paper subject to punch hole position adjustment.
Enter an adjustment value between -10 and 10 by tapping [-] and [+].
• [-]: Move the punch position to the left.
• [+]: Move the punch position to the right.
[0] is specified by default.
17
17-22