[Ae Level Adjustment]; [Printer Adjustment] - Muratec MFX-C2280 User's Manual Copy Operations

Settings
[Line Detection]
[Trail Edge Adjust]
[User Paper Settings]
[Erase Adjustment]
[PS Designer Settings]

[AE Level Adjustment]

To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [AE Level Adjustment]
Adjust the AE (Auto Exposure) level.
Tap [Higher] or [Lower] to adjust the automatic exposure to one of the five levels. The larger the number, the
darker the background.
[2] is specified by default.

[Printer Adjustment]

To display: [Utility] - [Administrator Settings] - [System Settings] - [Expert Adjustment] - [Printer Adjustment]
Adjust the print start position and defective print images.
Settings
[Leading Edge Adjustment]
[Centering]
[Leading Edge Adjustment
(Duplex Side 2)]
[Centering (Duplex 2nd
Side)]
[Erase Leading Edge]
[Vertical Adjustment]
[Media Adjustment]
Description of Setup Buttons (Administrator Settings)
Description
Set this option for the dirt detection level for the Slit Scan Glass and clean-
ing of the Slit Scan Glass.
For details, refer to page 17-27.
Correct the color misalignment if the trailing edge of the printed image is
out of alignment.
For details, refer to page 17-27.
Register special paper with [User Paper 1] through [User Paper 6]. Settings
to configure include Basic Weight and Media Adjustment. For details on
displaying this item, contact your service representative.
Specify the operation and erase method when erasing the area outside the
original by setting [Non-Image Area Erase].
For details, refer to page 17-28.
Specify whether to reproduce the colors in the original strictly as they are
when printing it using a PS driver from your computer.
For details, refer to page 17-28.
Description
Adjust the print start position at the leading edge of the paper relative to
the paper discharge direction.
For details, refer to page 17-14.
Adjust the print start position on the left edge of the paper relative to the
paper discharge direction.
For details, refer to page 17-14.
Adjust the print start position at the leading edge of the back side of the
paper relative to the paper discharge direction for printing the back side in
2-sided printing.
For details, refer to page 17-15.
Adjust the print start position at the left edge of the paper relative to the
paper discharge direction for printing the back side in 2-sided printing.
For details, refer to page 17-15.
Adjust leading edge erase width. For details, contact your service repre-
sentative.
Adjust the feed direction zoom ratio of paper types. For details, contact
your service representative.
Adjust print defects (voids, white spots, roughness) that are caused by pa-
per properties for each paper type.
For details, refer to page 17-16.
17
17-13