Dürkopp Adler 967 Service Instructions Manual page 71

Adjusting the thread system
Figure 48: Adjusting the winder – part 1
(1) - Bobbin lever
(2) - Regulating screw
(3) - Locknut
(4) - Bobbin
(5) - Winder pulley
(6) - Switch-off lever
Setting steps
1. Release the locknut (3).
2. Tighten the regulating screw (2) so that the arms of the winder lever (1)
3. Adjust the winder pulley (5) to a distance of L=8 mm from the internal
4. Loosen the screw (11).
5. Swing the switch-off lever (6) into the switch-off position, at which the
6. Tighten the screw (11).
7. Check that the winder switches off when the winder pulley (5) reaches
8. Turn the winder lever (1) to the position 0 (winder switched off).
9. Loosen the screw (10).
10.Adjust the blocking lever (9) to the base of the recess in the blocking
Service instructions 967 - 00.0 - 12/2014
are approximately parallel.
diameter of the bobbin (4).
edge of the spring (7) rests against the edge of the switch-off lever (6).
8 mm from the internal diameter of the bobbin (4); if necessary correct
the setting.
cam (8).
0.5 mm
(7) - Spring
(8) - Blocking cam
(9) - Blocking lever
(10) - Screw
(11) - Screw
69