Aligning The Feed Stroke Of The Feet - Dürkopp Adler 967 Service Instructions Manual

11.3 Aligning the feed stroke of the feet

The main purpose of this adjustment is to ensure that at the start of feed-
ing the presser foot is lifted above the material and the material feeding
movement is not prevented by the sewing foot.
Correct setting
When the stitch length is set to 0 and the stroke of the foot is set to 0:
 The lever is attached to the lift bar of the feet by the screw (5) in such
Cover
• Arm cover ( page 11)
• Head cover ( page 12)
Figure 42: Aligning the feed stroke of the feet
(1) - Presser foot
(2) - Sewing foot
(3) - Plate
Setting steps
1. Put the handwheel into the 0° position ( page 20).
2. Set the stitch length to 0.
3. Adjust the zero stroke of the feet ( page 59).
4. Loosen the screw (5).
5. Take the plate (3) out of its working position (4), turn it round and place
6. Move both feet manually down to the stop.
7. Tighten the screw (5).
62
a way that the presser foot (1) is 0.3 mm than the sewing foot (2).
it under the feet as illustrated so that the sewing foot (2) is 0.3 mm lower
than the presser foot (1).
Adjusting the sewing foot feed
(4) - Working position of the plate (3)
(5) - Screw fro the lever for raising the feet
Service instructions 967 - 00.0 - 12/2014