Dürkopp Adler 967 Service Instructions Manual page 73

Adjusting the thread system
Figure 49: Adjusting the winder – part 2
(1) - Bobbin lever
(2) - Screw
(3) - Locknut
(4) - Bobbin
(5) - Blocking lever
(6) - Blocking cam
Setting steps
1. Turn the winder lever (1) to the position 0 (winder switched off).
2. Loosen the screw (10).
3. Turn the eccentric (9) so that there is a gap of 0.5 mm between the
4. Tighten the screw (10).
5. Loosen the screws (8).
6. Adjust the position of the microswitch (7).
7. Tighten the screws (8).
8. Turn the blocking cam (6) in the direction of the arrow and switch on the
 The microswitch must not switch off (a clicking within the microswitch
9. Turn the winder shaft until the blocking lever (5) engages in the recess
 In this position the microswitch (7) must switch the motor off. If it does
Service instructions 967 - 00.0 - 12/2014
friction disc (12) and rubber pulley (11).
winder so that the blocking lever (5) rests on the outer diameter of the
blocking cam (6).
indicates when it switches off).
in the blocking cam (6).
not do this, correct the position of the microswitch.
(7) - Microswitch
(8) - Screws
(9) - Eccentric
(10) - Screw
(11) - Rubber pulley
(12) - Friction disc
71