Adjusting The Hook-Thread Guide - Dürkopp Adler 967 Service Instructions Manual

10.Mount the thread tensioning plate with the winder on to the machine.
11.Test the winder for correct operation. Check that the winder switches

13.3 Adjusting the hook-thread guide

Correct setting
The thread tensioning element (4) must be at a distance from the machine
arm such that the bobbin (2) is wound equally at both ends.
If due to the position of the thread tensioning element (4) the bobbin (2)
cannot be wound equally at both ends, the inclination of the hook-thread
guide (3) must be changed to achieve this.
Cover
• Upper right cover ( page 11).
Figure 50: Adjusting the thread tensioner and guide ahead of the winder
(1) - Setscrews
(2) - Bobbin
(3) - Hook-thread guide
72
off when the thread has been wound up to 0.5 to 1 mm below the outer
diameter of the bobbin (4).
If it does not do so, tighten screw (2) or back it off, and repeat the test.
Once the desired result has been obtained, tighten the locknut (3).
WARNING
Risk of injury
Switch off the machine before making adjustments.
Adjusting the thread system
(4) - Thread tensioning element
(5) - Screw
Service instructions 967 - 00.0 - 12/2014