Dürkopp Adler 967 Service Instructions Manual page 43

Setting the feed dog
Figure 28: Moving the feed dog carrier
(1) - Adjusting ring
(2) - Screws
(3) - Stroke shaft
(4) - Clamp
Setting steps
1. Position the upper stitch length adjusting wheel to 0.
2. Loosen the screw (6) and adjusting ring (7).
3. Loosen the screws (2) and adjusting ring (1).
4. Move the feed dog carrier across the line of the sewing direction such
5. Push the adjusting ring (1) and clamp (4) towards each other as far as
6. Tighten the setscrew of the adjustment ring (1) and the screws (2).
7. Push the adjusting ring (7) and clamp (8) towards each other as far as
8. Tighten the setscrew of the adjustment ring (7) and the screw (6).
Service instructions 967 - 00.0 - 12/2014
that the feed dog is exactly in the center of the throat plate cut-out.
they will go.
When doing this, make sure that the stroke shaft (3) is firmly held by
the clamp (4) and adjustment ring (1).
they will go.
When doing this, make sure that the sliding shaft (5) is firmly held by
the clamp (8) and adjustment ring (7).
(5) - Sliding shaft
(6) - Screw
(7) - Adjusting ring
(8) - Clamp
41