7,Rewriting Firmware and CWD Control Data
【Note】While rewriting firmware and CWD control data (when the green LED is blinking), do not
turn the printer OFF or unplug the USB cable
.
(1) Rewriting Firmware
① Turn the printer ON.
② Run OP2-Tools, and select the printer for firmware rewriting.
③ Under the "Option" menu, click on "Flash rom writer".
④ The file selection window will open. Select the ROM data for rewriting, and click on the "Open"
button.
⑤ About 25 seconds after clicking on the "Open" button, the ROM data transmission will begin, and the
firmware rewriting will begin. When rewriting the firmware, the green LED will blink.
*Depending on computer performance, the time to data transmission may differ slightly.
⑥ When rewriting is complete, the printer will beep, and the LED will turn green.
It is not necessary to reboot the printer.
⑦ Under the "Status" menu, click on "ROM Version", then click on "Get".
Check that the rewritten ROM version is correct.
57