Table of Contents
Advertisement
(5) Mechanism Adjustment
To display the current print position and cut scrap length adjustment values, click on "Get".
① Cutting position adjustment
This adjusts the cut scrap length for the first print.
Print one all-gray sheet. Then measure the cut scrap length from it.
Enter the adjustment value and click on "Setup". The adjustment value will be written to
the printer.
Print result
Scrap length is
shorter than 5.5 ㎜
Scrap length is
longer than 5.5 ㎜
■Example
5.5mm → Adj value 0.0mm
5.0mm → Adj value +0.5mm
6.0mm → Adj value -0.5mm
Cause
Distance from the sensor to the
cutter is longer than ideal.
Distance from the sensor to the
cutter is shorter than ideal.
43
Correction
Increase (+) the Cutting position
→
adjustment by the length lacking
Decrease (-) the Cutting position
→
adjustment by the excess length
Enter the adjustment value
Advertisement
Table of Contents
