Table of Contents
Advertisement
② Print position adjustment
This adjusts the length of the remaining printed area on the print scrap (post-printing) from
the second and later prints.
Print 2 successive all-gray sheets. Then measure the remaining print length.
Enter the adjustment value and click on "Setup". The adjustment value will be written to
the printer.
Print result
Remaining print length
is less than 0.8 ㎜
Remaining print length
is more than 0.8 ㎜
■Example
0.80mm
→ Adj value 0.0mm
0.30mm
→ Adj value -0.5mm
1.30mm
→ Adj value +0.5mm
Scrap length 5.5mm
Feed direction
Cause
Distance from the sensor to
the head is longer than ideal.
Distance from the sensor to
the head is shorter than ideal.
Enter the adjustment value
44
Correction
Decrease (-) the Print position
→
adjustment by the length lacking
Increase (+) the Print position
→
adjustment by the excess length
Advertisement
Table of Contents
