4, Disassembly, Assembly(Mechanical Assy)
Replacement Procedure 4-68 Auto Cutter Unit
①4-60 Wiring Harness 4pin(refer to the figure below)
②2-12 2pin(the figure below)
③Remove from the printer in the screw 2 locations.
④Remove the 4-681 in the screw 2 locations.
Note) You need to adjust the print position and cut position.
(refer to Ch.4)
Replacement Procedure 4-9 BELT_TIMING
Loosen the 4-50 PLATE_TENSIONER screw.
Note) The belt tension is set correctly with 4-6 spring_tension.
Be sure not to move it when loosening screws.
Replacement Procedure 4-33 ROLLER_PLATEN
①4-42 Spacer_Platen_Roller
②2. Slide the 4-33 ROLLER_PLATEN and remove.
Note) Be careful not to drop or lose the 4-28 Bearing (d6-D10 F).
③4-27 Bearing(d10-D15) and 4-47 E Ring
4-68Auto Cutter Unit
4pin
4-68 Auto Cutter Unit
2pin
Mecha Flame R Assy
22