CT-S310II Series Service Manual
INTRODUCTION
This manual describes the disassembly, reassembly, and maintenance procedures of
Series.
1. DISASSEMBL Y AND REASSEMBLY
Note the following items when performing maintenance of the printer.
Do not disassemble, reassemble, or adjust the printer unnecessarily when the printer operation is
satisfactory.
Do not loosen the screws that fasten the components unless it is absolutely necessary.
After finishing inspection, perform a check to ensure that there is no irregularity before turning on the
printer.
Use caution not to leave any part or screw used for maintenance inside the printer.
When handling the print head and electronic components, care must be taken to avoid static electricity.
When disassembling or reassembling the printer, check the wires and cords for damage. Do not draw
any wire or cord by force.
Lubricate the components as necessary when reassembling them.
1-1. T ools Used
Phillips screwdriver #0, #1, and #2
Tweezers (metallic not allowed)
Long-nose pliers
Brush
- 4 -
CT-S310II