ZyXEL Communications P-660R-T1 Support Notes page 73

More= No
Action Matched= Drop
Action Not Matched= Forward
Key Settings:
•
Generic Filter Ruls
Set the 'Filter Type' to 'Generic Filter Rule'
•
Active
Turn 'Active' to 'Yes'
•
Offset (in bytes)
Set to '6' since the source MAC address starts at 7th octets we need to skip the
first octets of the destination MAC add
Length (in bytes)
Set to '6' since MAC address has 6
Mask (in hexadecimal)
Specify the value that the P-660 will logi
in the packet.
Since the Length is set to 6 o
numbers. In this case, we intent to se
source MAC address, [00 80 c8
•
Value (in hexadecimal)
Specify the MAC address
compare with the masked packe
the 'Value', then the packet is considered m
•
Action Matched=
Enter the action you want if the masked p
case, we will drop it.
•
Action Not Matched=
Enter the action you want if the masked packet does not match the 'Value'
this case, we will forward it. If you want to configure more rules please select
'Check Next Rule' to start configuring the next new rule. However, please note
that the 'Filter Type' must be also 'Generic Filter Rule' but
the Generic and TCPIP (IPX) filter rules must be in different filter sets.
All contents copyright © 2005 ZyXEL Communications Corporation.
Log= None
ress.
octets.
ctets the Mask for it should be 12 hexadecimal
t to 'ffffffffffff' to mask the incoming
4c ea 63].
[00 80 c8 4c ea 63]
t. If the result from the masked packet matches
P-660 series Support Notes
cally qualify (logical AND) the data
that the P-660 should use to
atched.
acket matches the 'Value'. In this
not others. Because
. In
72