ZyXEL Communications P-660R-T1 Support Notes page 111

• Using Zero configuration.
1. After configure the auto-haunting preconfigured table. You just need a PC
connected to the device LAN Ethernet port with the DSL sync up.
2. Open your web browser to access a Web site. It should prompt and request
for your username password of your ISP
or PPPoA service.
3. After key-in the correct info, it will than test the connection. If it is
successful it will than close the browser and you can open a new browser to
surf the Internet. If the connection test fail, it will go back to the page ask for
user name and password.
The user name or password are incorrect. You need to keyin again to retry.
All contents copyright © 2005 ZyXEL Communications Corporation.
Remove <removeNodeId>
<vpi> <vci>
Active <yes|no>
display
Clear
Save
timer
Send
result
account, if your ISP provide PPPoE
P-660 series Support Notes
bit4:Enet/VC (16),
bit5 :Enet/LLC (32)
For examples:
If you need service PPPoE/LLC
and Enet/LLC then the service
bits will be 2+32 = 34 (decimal)
= 22 (hex), you must input 22
Need to perform save after this
command
Input remote node ID and vpi,
vci value to remove the specific
entry. System will save
automatically.
Enable VC auto hunting featurer
Display the hunt pool
Clear the configure buffer
Save current setting into ROM
file
The waiting time before
checking the hunting table result
Send VC hunt pattern again
Check the result of V C auto
hunting
110