Configure Wan Ip Settings; Isp And Wan Connection Settings - ZyXEL Communications UAG5100 User Manual

Otherwise, choose PPPoE or PPTP for a dial-up connection according to the information from your
ISP.
Figure 41 WAN Interface Setup: Step 2
The screens vary depending on what encapsulation type you use. Refer to information provided by
your ISP to know what to enter in each field. Leave a field blank if you don't have that information.
Note: Enter the Internet access information exactly as your ISP gave it to you.

5.2.3 Configure WAN IP Settings

Use this screen to select whether the interface should use a fixed or dynamic IP address.
Figure 42 WAN Interface Setup: Step 2
• WAN Interface: This is the interface you are configuring for Internet access.
• Zone: This is the security zone to which this interface and Internet connection belong.
• IP Address Assignment: Select Auto If your ISP did not assign you a fixed IP address.
Select Static if you have a fixed IP address.

5.2.4 ISP and WAN Connection Settings

Use this screen to configure the ISP and WAN interface settings. This screen is read-only if you
select Ethernet and set the IP Address Assignment to Auto. If you set the IP Address
Chapter 5 Quick Setup Wizards
UAG Series User's Guide
66