Add/Edit Trusted Radius Client - ZyXEL Communications UAG5100 User Manual

46.12.1 Add/Edit Trusted RADIUS Client

Click Configuration > System > Auth. Server to display the Auth. Server screen. Click the Add
icon or an Edit icon to display the following screen. Use this screen to create a new entry or edit an
existing one.
Figure 371 Configuration > System > Auth. Server > Add/Edit
The following table describes the labels in this screen.
Table 250 Configuration > System > Auth. Server > Add/Edit
LABEL
Activate
Profile Name
IP Address
Netmask
Secret
Description
OK
Cancel
Chapter 46 System
DESCRIPTION
Select this check box to make this profile active.
Enter a descriptive name (up to 31 alphanumerical characters) for identification purposes.
Enter the IP address of the RADIUS client that is allowed to exchange messages with the
UAG.
Enter the subnet mask of the RADIUS client.
Enter a password (up to 64 alphanumeric characters) as the key to be shared between the
UAG and the RADIUS client.
The key is not sent over the network. This key must be the same on the external
authentication server and the UAG.
Enter the description of each server, if any. You can use up to 60 printable ASCII
characters.
Click OK to save the changes.
Click Cancel to discard the changes.
UAG Series User's Guide
530