Quick Setup Interface Wizard: Summary - ZyXEL Communications UAG5100 User Manual

Table 12 WAN and ISP Connection Settings (continued)
LABEL
Password
Retype to
Confirm
Nailed-Up
Idle Timeout
PPTP Configuration
Base Interface
Base IP Address
IP Subnet Mask
Gateway IP
Address
Server IP
Connection ID
IP Address
Assignment
WAN Interface
Zone
IP Address
Gateway IP
Address
First DNS
Server
Second DNS
Server
Back
Next

5.2.5 Quick Setup Interface Wizard: Summary

This screen displays the WAN interface's settings.
Chapter 5 Quick Setup Wizards
DESCRIPTION
Type the password associated with the user name above. Use up to 64 ASCII characters
except the [] and ?. This field can be blank.
Type your password again for confirmation.
Select Nailed-Up if you do not want the connection to time out.
Type the time in seconds that elapses before the router automatically disconnects from
the PPPoE server. 0 means no timeout.
This section only appears if the interface uses a PPPoE or PPTP Internet connection.
This displays the identity of the Ethernet interface you configure to connect with a
modem or router.
Type the (static) IP address assigned to you by your ISP.
Type the subnet mask assigned to you by your ISP (if given).
This field only displays for an interface with a static IP address. Enter the IP address of
the gateway device.
Type the IP address of the PPTP server.
Enter the connection ID or connection name in this field. It must follow the "c:id" and
"n:name" format. For example, C:12 or N:My ISP.
This field is optional and depends on the requirements of your DSL modem.
You can use alphanumeric and -_
This displays the identity of the interface you configure to connect with your ISP.
This field displays to which security zone this interface and Internet connection will
belong.
This field is read-only when the WAN interface uses a dynamic IP address. If your WAN
interface uses a static IP address, enter it in this field.
This field only displays for an interface with a static IP address. Enter the gateway's IP
address.
These fields only display for an interface with a static IP address. Enter the DNS server
IP address(es) in the field(s) to the right.
Leave the field as 0.0.0.0 if you do not want to configure DNS servers. If you do not
configure a DNS server, you must know the IP address of a machine in order to access
it.
DNS (Domain Name System) is for mapping a domain name to its corresponding IP
address and vice versa. The DNS server is extremely important because without it, you
must know the IP address of a computer before you can access it. The UAG uses a
system DNS server (in the order you specify here) to resolve domain names for DDNS
and the time server.
Click Back to return to the previous screen.
Click Next to continue.
UAG Series User's Guide
68
characters, and it can be up to 31 characters long.
: