ZyXEL Communications UAG5100 User Manual page 126

Table 48 Monitor > Log (continued)
LABEL DESCRIPTION
Priority This displays when you show the filter. Select the priority of log messages to display. The
log displays the log messages with this priority or higher. Choices are: any, emerg,
alert, crit, error, warn, notice, and info, from highest priority to lowest priority. This
field is read-only if the Category is Debug Log.
Source Address This displays when you show the filter. Type the source IP address of the incoming packet
that generated the log message. Do not include the port in this filter.
Destination This displays when you show the filter. Type the IP address of the destination of the
Address incoming packet when the log message was generated. Do not include the port in this
filter.
Source Interface This displays when you show the filter. Select the source interface of the packet that
generated the log message.
Destination This displays when you show the filter. Select the destination interface of the packet that
Interface generated the log message.
Service This displays when you show the filter. Select the service whose log messages you would
like to see. The Web Configurator uses the protocol and destination port number(s) of the
service to select which log messages you see.
Keyword This displays when you show the filter. Type a keyword to look for in the Message,
Source, Destination and Note fields. If a match is found in any field, the log message
is displayed. You can use up to 63 alphanumeric characters and the underscore, as well
as punctuation marks ()' ,:;?! +-*/= #$% @ ; the period, double quotes, and brackets
are not allowed.
Protocol This displays when you show the filter. Select a service protocol whose log messages you
would like to see.
Search This displays when you show the filter. Click this button to update the log using the
current filter settings.
Reset This displays when you show the filter. Click this button to return the screen to its last-
saved settings.
Email Log Now Click this button to send log message(s) to the Active e-mail address(es) specified in the
Send Log To field on the Log Settings page (see
Refresh Click Refresh to update this screen.
Clear Log Click this button to clear the whole log, regardless of what is currently displayed on the
screen.
# This field is a sequential value, and it is not associated with a specific log message.
Time This field displays the time the log message was recorded.
Priority This field displays the priority of the log message. It has the same range of values as the
Priority field above.
Category This field displays the log that generated the log message. It is the same value used in
the Display and (other) Category fields.
Message This field displays the reason the log message was generated. The text "[count=x]",
where x is a number, appears at the end of the Message field if log consolidation is
turned on (see Log Consolidation in
aggregated to generate into this one.
Source This field displays the source IP address and the port number in the event that generated
the log message.
Source Interface This field displays the source interface of the packet that generated the log message.
Destination This field displays the destination IP address and the port number of the event that
generated the log message.
Destination This field displays the destination interface of the packet that generated the log message.
Interface
Chapter 7 Monitor
Table 257 on page
UAG Series User's Guide
126
Section 47.3.2 on page 538).
540). and multiple entries were