Vpn Express Wizard - Configuration; Vpn Express Wizard - Summary - ZyXEL Communications UAG5100 User Manual

Rule Name: Type the name used to identify this VPN connection (and VPN gateway). You may use
1-31 alphanumeric characters, underscores (_), or dashes (-), but the first character cannot be a
number. This value is case-sensitive.
Application Scenario: This shows the scenario that the UAG supports.
• Site-to-site - The remote IPSec device has a static IP address or a domain name. This UAG can
initiate the VPN tunnel.

5.3.4 VPN Express Wizard - Configuration

Figure 49 VPN Express Wizard: Configuration
• Secure Gateway: Enter the WAN IP address or domain name of the remote IPSec device
(secure gateway) to identify the remote IPSec router by its IP address or a domain name.
• Pre-Shared Key: Type the password. Both ends of the VPN tunnel must use the same password.
Use 8 to 31 case-sensitive ASCII characters or 8 to 31 pairs of hexadecimal ("0-9", "A-F")
characters. Proceed a hexadecimal key with "0x". You will receive a PYLD_MALFORMED (payload
malformed) packet if the same pre-shared key is not used on both ends.
• Local Policy (IP/Mask): Type the IP address of a computer on your network that can use the
tunnel. You can also specify a subnet. This must match the remote IP address configured on the
remote IPSec device.
• Remote Policy (IP/Mask): Type the IP address of a computer behind the remote IPSec device.
You can also specify a subnet. This must match the local IP address configured on the remote
IPSec device.

5.3.5 VPN Express Wizard - Summary

This screen provides a read-only summary of the VPN tunnel's configuration and commands that
you can copy and paste into another ZLD-based UAG's command line interface to configure it.
Chapter 5 Quick Setup Wizards
UAG Series User's Guide
72