Ip/Mac Binding Summary - ZyXEL Communications UAG5100 User Manual

Interfaces Used With IP/MAC Binding
IP/MAC address bindings are grouped by interface. You can use IP/MAC binding with Ethernet,
bridge, VLAN interfaces. You can also enable or disable IP/MAC binding and logging in an interface's
configuration screen.

20.2 IP/MAC Binding Summary

Click Configuration > Network > IP/MAC Binding to open the IP/MAC Binding Summary
screen. This screen lists the total number of IP to MAC address bindings for devices connected to
each supported interface.
Figure 168 Configuration > Network > IP/MAC Binding > Summary
The following table describes the labels in this screen.
Table 107 Configuration > Network > IP/MAC Binding > Summary
LABEL
Edit
Activate
Inactivate
#
Status
Interface
Number of
Binding
Apply
Chapter 20 IP/MAC Binding
DESCRIPTION
Double-click an entry or select it and click Edit to open a screen where you can modify the
entry's settings.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
This field is a sequential value, and it is not associated with a specific entry.
This icon is lit when the entry is active and dimmed when the entry is inactive.
This is the name of an interface that supports IP/MAC binding.
This field displays the interface's total number of IP/MAC bindings and IP addresses that the
interface has assigned by DHCP.
Click Apply to save your changes back to the UAG.
UAG Series User's Guide
249