Host Name; Usb Storage - ZyXEL Communications UAG5100 User Manual

Note: See each section for related background information and term definitions.

46.2 Host Name

A host name is the unique name by which a device is known on a network. Click Configuration >
System > Host Name to open the Host Name screen.
Figure 327 Configuration > System > Host Name
The following table describes the labels in this screen.
Table 230 Configuration > System > Host Name
LABEL
System Name
Domain Name
Apply
Reset

46.3 USB Storage

The UAG can use a connected USB device to store the system log and other diagnostic information.
Use this screen to turn on this feature and set a disk full warning limit.
Note: Only connect one USB device. It must allow writing (it cannot be read-only) and
use the FAT16, FAT32, EXT2, or EXT3 file system.
Click Configuration > System > USB Storage to open the screen as shown next.
Chapter 46 System
DESCRIPTION
Enter a descriptive name to identify your UAG device. This name can be up to 64
alphanumeric characters long. Spaces are not allowed, but dashes (-) underscores (_) and
periods (.) are accepted.
Enter the domain name (if you know it) here. This name is propagated to DHCP clients
connected to interfaces with the DHCP server enabled. This name can be up to 254
alphanumeric characters long. Spaces are not allowed, but dashes "-" are accepted.
Click Apply to save your changes back to the UAG.
Click Reset to return the screen to its last-saved settings.
UAG Series User's Guide
487