Add/Edit An Radius Server - ZyXEL Communications SBG5500-A User Manual

9.11.2 Add/Edit an RADIUS Server

Click Add icon or select a server and click Edit to display the following screen. Use this screen to create
a new RADIUS entry or edit an existing one.
Figure 126 RADIUS Server: Add/Edit
The following table describes the labels in this screen.
Table 67 RADIUS Server: Add/Edit
LABEL
General Settings
Name
Description
Server Settings
Server Address
Authentication Port
Backup Server Address
Backup Authentication Port
Timeout
Chapter 9 Firewall
DESCRIPTION
Enter a descriptive name (up to 64 alphanumerical characters) for identification
purposes.
Enter the description of each server, if any. You can use up to 128 printable ASCII
characters.
Enter the IP address or FQDN of the RADIUS authentication server.
Specify the port number on the RADIUS server to which the SBG sends
authentication requests. Enter a number between 1 and 65535.
If the RADIUS server has a backup authentication server, enter its IP address or FQDN
here.
Specify the port number on the RADIUS server to which the SBG sends
authentication requests. Enter a number between 1 and 65535.
Specify the timeout period (between 1 and 300 seconds) before the SBG
disconnects from the RADIUS server. In this case, user authentication fails.
Search timeout occurs when either the user information is not in the RADIUS server or
the RADIUS server is down.
SBG5500 Series User's Guide
157