Installing The Oil Pump; Installing The Oil Strainer; Installing The Oil Pan - Yamaha 2007 FZ6-NA Service Manual

3. Check:
• Oil pump operation
Refer to "CHECKING THE OIL PUMP" on
page 5-43.
EAS25030

INSTALLING THE OIL PUMP

1. Install:
• Oil pump drive chain
• Gear cover
• Oil pump
• Oil pump bolts
Oil pump bolt
12 Nm (1.2 m·kg, 8.7 ft·lb)
ECA4S81018
CAUTION:
After tightening the bolts, make sure the oil
pump turns smoothly.
EAS25040

INSTALLING THE OIL STRAINER

1. Install:
• Oil strainer "1"
• Relief valve "2"
NOTE:
Make sure to check the arrow mark "a" located
on the oil strainer housing for the front and rear
direction of the engine and then install the oil
strainer so that its arrow mark points to the
front side of the engine.
EAS25050

INSTALLING THE OIL PAN

1. Install:
• Oil pipe
• Oil delivery pipe
2. Install:
• Dowel pins
• Gasket New
• Oil pan "1"
Oil pan bolt
12 Nm (1.2 m·kg, 8.7 ft·lb)
• Oil level switch "2"
Oil level switch bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
• Engine oil drain bolt
Engine oil drain bolt
43 Nm (4.3 m·kg, 31 ft·lb)
EWA12820
WARNING
Always use new copper washers.
NOTE:
• Tighten the oil pan bolts in stages and in a
crisscross pattern.
• Lubricate the oil level switch O-ring with
engine oil.
5-45
OIL PUMP