Yamaha 2007 FZ6-NA Service Manual page 236

• Clutch cable
NOTE:
Align the slit on the clutch lever holder with the
punch mark "a" on the handlebar.
6. Install:
• Left handlebar switch
NOTE:
Align the projection "a" on the left handlebar
switch with the hole "b" on the handlebar.
7. Install:
• Handlebar grip
• Grip end
Grip end
26 Nm (2.6 m·kg, 19 ft·lb)
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Apply a thin coat of rubber adhesive onto
the left end of the handlebar.
b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
8. Adjust:
• Throttle cable free play
Refer to "ADJUSTING THE THROTTLE
CABLE FREE PLAY" on page 3-10.
Throttle cable free play
3.0–5.0 mm (0.12–0.20 in)
9. Adjust:
• Clutch cable free play
Refer to "ADJUSTING THE CLUTCH
CABLE FREE PLAY" on page 3-16.
4-63
HANDLEBAR