Yamaha 2007 FZ6-NA Service Manual page 313

5. Install:
• Friction plates
• Clutch plates
NOTE:
First, install a friction plate and then alternate
between a clutch plate and a friction plate.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Install the clutch plate and friction plate as
shown in the illustration.
Clutch plate "1": t=2.3 mm (0.09 in)
Clutch plate "2": t=2.0 mm (0.08 in)
Friction plate "3"
Friction plate "4": Color/Brown
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
6. Install:
• Pressure plate "1"
NOTE:
Align the punch mark "a" in the pressure plate
with the punch mark "b" in the clutch boss.
7. Install:
• Bearing "1"
• Pill rod "2"
• Pressure plate "3"
• Clutch springs
• Clutch spring bolts
Clutch spring bolt
8 Nm (0.8 m·kg, 5.8 ft·lb)
NOTE:
Tighten the clutch spring bolts in stages and in
a crisscross pattern.
8. Install:
• Pull lever
9. Install:
• Clutch cover
• Gasket
New
• Clutch cable holder
NOTE:
• Install the pull rod so that the teeth a face
towards the rear of the vehicle. Then, install
the clutch cover.
• Apply oil onto the bearing.
• Apply molybdenum disulfide grease onto the
pull rod.
• When installing the clutch cover, push the
pull lever and check that the punch mark "a"
on the pull lever aligns with the mark "b" on
the clutch cover. Make sure that the pull rod
teeth and pull lever shaft pinion gear are
engaged.
• Tighten the clutch cover bolts in stages and
in a crisscross pattern.
10. Adjust:
• Clutch cable free play
Refer to "ADJUSTING THE CLUTCH
CABLE FREE PLAY" on page 3-16.
5-52
CLUTCH