Yamaha 2007 FZ6-NA Service Manual page 109

FZ6-SA/FZ6-SAHG
1. Main switch and immobilizer lead
2. Stay assembly
3. Left handlebar switch lead
4. Clutch cable
5. Throttle cables
6. Battery negative lead coupler
7. Starter relay lead
8. Battery negative lead
9. Fuel tank drain hose
10.Hydraulic unit lead
11.Rectifier/regulator
12.Turn signal relay
13.Radiator fan motor relay
14.Starting circuit cut-off relay
15.Clamp
16.License plate light lead
17.Rear turn signal light lead (right)
18.Rear turn signal light lead (left)
19.Dimmer relay
20.Speed sensor lead
21.Sidestand switch lead
22.Oil level switch lead
23.AC magneto lead
24.Front brake hose
25.Throttle cable (return side)
26.Throttle cable (pull side)
27.Radiator fan motor lead
28.ABS check coupler
29.Connector
A. Route the throttle cables above the stay
assembly1.
B. Route the main switch and immobilizer
lead above the clutch cable.
C. Line up the left handlebar switch lead cou-
pler and radiator fan motor lead coupler
behind the head pipe.
D. Route the clutch cable over the wire har-
ness.
E. To the immobilizer
F. To the main switch
G. Place three couplers on the flange of the
cover.
H. To the front wheel sensor. Place the
between frame and clutch cable on the
clutch cable fixing bracket.
I. To the fuel pump
J. Clamp four wire leads. There should be no
excessive slack on the wire leads.
K. To the fuel tank
L. Either installation position can be
accepted, but make sure that the leads are
not crossed.
M. Clamp the rear turn signal lead and license
plate light lead to the frame. Hook the
clamp to the bracket. Pull out the lead suffi-
ciently to the frame side and route it along
with the side of the back stay. Cut the tip of
the clamp to be between 1 and 5 mm (0.04
and 0.20 in) upward.
N. Clamp the rear turn signal light lead and
license plate light lead to the frame. Cut the
tip of the clamp to be between 1 and 5 mm
(0.04 and 0.20 in).
O. Gap between the lead and muffler should
be 10 mm (0.39 in) or more.
P. Coupler should not run on the relay assem-
bly.
Q. To the tail/brake light
R. To the license plate light
S. To the rear turn signal light (right)
T. To the rear turn signal light (left)
U. To the engine
V. Route the speed sensor lead behind the
starter motor lead
W. Point the bend-R section of the throttle
cable (pull side) to the inner side horizon-
tally. It is also possible to visually check the
bend-R section.
X. Attach the ABS check coupler to the
bracket after inserting the connector.
Y. To the headlight lead
Z. Clamp the seat lock cable to the frame as
shown in the illustration. Secure the clamp
to the weld of the cross member with the
frame. Position the binding section in front
of the vehicle body and cut the tip to be
between 1 and 5 mm (0.04 and 0.20 in).
AA.Point the tip of the clamp to the inner side
of the vehicle body.
2-64
CABLE ROUTING